Candle Carving

MADE IN THE USA - This base fits all sizes of our carving rack tops (sold separately). The bottom of the base is equipped with 4 anti-slip rubber pads to minimize the movement of the base while you are carving. Since the carving rack tops are...

MADE IN THE USA - The candle handle holds the candle while it is being dipped, carved, glazed, and dried. The handle is fastened into the candle by an expansion plug which is expanded by the turning of a wingnut at the top of the handle.

Get carving quickly with our pre-made cores made especially for the Candlefun system.

MADE IN THE USA - This carving rack top is made for 9 inch candles and works together with the carving base to keep your candle secure and hands-free while carving.This rack sits in the base (sold separately). All rack tops fit the same rack base. The...

Holds 3 wells for carving 6" candles.

MADE IN THE USA - A handy rack to have above your glaze to allow excess to drip back into the bucket.Easy to assemble and comes complete with a stirring stick.

MADE IN THE USA - The marking tool is used to place small indents on the soft candle. By lining up the tool with marks on the marking strip, and then pressing the stiff wire into the soft candle, you can mark the candle so that you can see where certain...

This tapered metal cylinder mold produces a core candle with a top diameter of 1.75 inches and bottom diameter of 2.25 inches. The molds are converted to hold oil tubes.Use in the Candlefun Wedding Tapers DVDMADE IN THE USA

The molds produce cores with tops measuring 2.5" from star tip to opposing star tip. The core bottoms, star tip to star tip, are 4 inches. The molds are converted to hold oil tubes.

Easily convert any mold to be compatible with the Candlefun Carving system!  This conversion kit is for candle carvers who already own molds and want to convert them to start making the cut and carve candles. How it works:  the mold peg is...

MADE IN THE USA - The assembly tool holds the mold peg securely while it is being fastened to the bottom of a mold. There is a screw which protrudes into the tool. When the mold peg is placed into the end of the tool, the screw fits into the notch at the...